This Switch panel has Accommodations for the Factory Downhill Assist Control Button along side 7 5-Pin Switches. This is the Print file only. You will need 4x M4×10mm screws.
Print Settings:
3 Walls
20% Infill
0.16mm Layers
Installation:
Use the gasket to mark out where to cut, then install the switch panel, run the wires through each Switch location then Connect the switch and Press it into place, You should get a Kind of loud snap once its in place.
This Switch panel has Accommodations for the Factory Downhill Assist Control Button along side 7 5-Pin Switches. This is the Print file only. You will need 4x M4×10mm screws.
Print Settings:
3 Walls
20% Infill
0.16mm Layers
Installation:
Use the gasket to mark out where to cut, then install the switch panel, run the wires through each Switch location then Connect the switch and Press it into place, You should get a Kind of loud snap once its in place.
